Basic Concrete Polishing Maintenance

Basic Concrete Polishing Maintenance Program

These may vary depending on location:

Sweep/dry mop daily

Prosoco Daily Klean

Prosoco LS Klean 2xWeekly

 Dust mop the floor daily with a microfiber pad to keep dirt particles off the floor. Soils act as an

abrasive and can ruin the clarity and shine of polished concrete.

 If wet mopping the floor, always use CLEAN water and CLEAN MOPS. Use an automatic floor

scrubber with the Daily Klean or LS klean, and equipped with a nonabrasive

pad/wheels/squeegees/rollers(WHITE or BUFF Pad)*NO RED OR BLACK* to clean large square

footage areas. Clean Mop and bucket cleaning can be used in smaller areas.

 When wet mopping, use a neutral floor cleaner (Daily Klean) formulated to suspend the dirt

particles so they can be more easily removed. Using water only leaves much of the dirt on the

floor, where it will eventually abrade and discolor the surface.

 Give the cleaner enough time to start breaking down the grime, such grease and other

contaminants, and then suspend the particles. If you apply a cleaning agent and then

immediately vacuum it or mop it from the surface, the cleaner will not have sufficient time to

work.

 Make sure the cleaning solution DOES NOT DRY on the surface. This can be accomplished by

cleaning small areas and making sure the entire process is complete before moving on to other

areas.

 Try to clean spills and stains from the floor as quickly as possible so they don't absorb into the

surface and cause staining/etching.

Daily Klean packet in the auto scrubber solution done - DAILY

LS Klean packet in the auto scrubber solution done - 2x Week(depending on foot traffic/area)

Rejuvenate Floors with LS Guard every 6months. Light mist and spread with a microfiber pad,

then high-speed burnish(2000rpm) with a white pad to 92degrees after machine pass.